Galaxy DX Radios Symptom and Cure Database
Search Add A Record Administration Login | Logout
Search Results

Total Found: 97 records
16 - 30 shown below

<< Previous Next >>
ModelSymptomCategory Action
DX99V SSB TX distorted, AM transmit seems ok. Also TX power seems below normal on peaks. TX View   
DX99V Very low RX sensitivity. Voltages on TR9, TR10 and TR11 lower than normal. RX View   
DX2527 The PA led does not come on in PA mode. Other View   
DX44V RF Gain control doesn't seem to be working on strong incoming signals. RX View   
DX959 No channel LED, no Roger Beep LED. Other View   
DX44V Intermittent modulation but roger beep always works. TX View   
DX44V RX sensitivity is seems to be about 2-3uv higher than normal. RX View   
DX44V No modulation signal on the scope at the output of IC4 pin 1 with good signal at input of IC4 pin 3. No change after replacing IC4. TX View   
All 10 Meter Mobile EXCESSIVE RF NOISE BUT SIGNAL IS GOOD AT 455 FILTER RX View   
DX99V Low RX sens, Low RX ambient noise level. Changed all transistors in RX circuit and still no change. RX View   
All 10 Meter Mobile Excessive noise on receive and low receiver sensitivity and High noise level at TR17. RX View   
DX73V RF Power Meter does not adjust properly VR8 does not have enough range. TX View   
DX73V Loss of Talk Back when using Road King 56 microphone. TX View   
DX77HML Excessive noise on transmit with mic gain off, DC voltage is leaking into the audio through C128 TX View   
All CB Mobile SWR ALERT LED stays on when SWR is below 3:1 Q1 on SWR PC board is too sensitive TX View   
.
<< Previous Next >>


© CBTricks